1PCS DF-96D Automatic Water Level Controller Switch 20A 220V Water Tank Liquid Level Detection Sensor Water Pump Controller 2m Wires(DF-96DK with Probes)

Water PumpsWater Level Controller SwitchSpecificationType:DF-96DUpdatedversionWorkingvoltage:AC220V/50HZMaxCurrent:20AInstallation:DinRailMountPowerconsumption2Wtransmissionsignal:500MSize:126*88*51mmPackage include:1pcsAutomatic Water Level Controller Switch3pcs 200CM SensorSingle-control UP pool (water storage) installation instructions shown in figure 1A(red)-Upper water level control point. When water level gets to A point,the probe touch water and controller can stop the pump by auto.B(blue)-Lower water level control point. When water level gets off B point,the probe out of water and controller can start the pump by auto.C(black)-Should be placed in bottom of pool as the common line.D(green) and E(yellow)are connected with C (black).Single-control DOWN pool(drain water)installation instructions shown in figure 2.E-Upper water level control point. When water level gets to E point,the probe touch water and controller can start the pump by auto.D-Lower water level control point. As liquid level gets off D point,the probe out of water and controller can stop the pump by auto.C-Should be placed in bottom of pool as the common line.A&Bdisconnected1 Lack of water protection installation instructions shown in figure 3CDLower water level control points When water level gets off this pointC or D probe out of water and controller can stop the pump by autoECshortconnected;A&Bdisconnected2 Joint control UP and DOWN pool installation instructions shown in figure 4AUpper water level control point in UP pool When water level gets to A pointthe probe touch water and controller can stop the pump by autoBLower water level control point in UP pool When water level gets off A point the probe out of water and controller can start the pump by autoCShould be placed in bottom of UP and DOWN pools as the common lineDLower water level control point in DOWN pool When water level gets off D point the probe out of and controller can stop the pump by autoEUpper water level control point in DOWN pool When water level gets to E point the probe water and controller can start the pump by auto Then pool starts to drain water If not E point disconnectedUsed to solve problem1 On power but no worka Check the red indicator is on or not If not make the connection is good enough;2. When water level is above or below probes but the pump does not start or stop by auto, Please check it like the following.a. Whether the probe is placed too high or low so that water level can or out of it;b. The connection of upper &lower line or probe is dislocation by error or short connected;c. To check the probe whether it is rust or not or the connection is good enough.d. C- Check the common line whether it is placed in the lowermost bottom of pool.DF-96DKmodelDF-96Dmodel

• Water Pumps
• 1PCS DF-96D Automatic Water Level Controller Switch 20A 220V Water tank Liquid Level Detection Sensor Water Pump Controller 2m wires